SMD Tools

SMD Amp Dyno (AD-1)

SMD IM-SG+ (Impedance Meter / Signal Generator PLUS)

THE SMD IM-SG+ (Impedance Meter / Signal Generator PLUS) Some Uses: •Obtain a driver's T/S Parameters* •Determine speaker crossover set points •Find tuning frequency of passive radiator •Find tuning frequency of ported...

SMD Audio Multimeter AMM-1

The purpose of this tool is to enable the user to: Measure True Amplifier Power output into any load reactive or resistive Measure Common DC voltages Measure DC voltage drops during quick transients on cable runs or battery / charging systems Measure...

SMD Distortion Detector Plus (DD-1+)

The purpose of this tool is to enable the installer to set the gain of an audio amplifier to match the source unit’s output level, accurately and quickly. It can also be useful for detecting distortion in the audio signal caused by poorly designed...

SMD Distortion Detector DD-1

The purpose and benefit of the D’Amore Engineering / SMD Distortion Detector. The purpose of this tool is to enable the installer to set the gain of an audio amplifier to match the source unit’s output level, accurately and quickly. It can...

SMD Crossover Calibrator CC-1

The purpose and benefit of the D’Amore Engineering / SMD Crossover Calibrator. Most modern car audio amplifiers have a built in crossover on the side. Usually, it will start at 30hz and have a huge gap, all the way up to (sometimes) 500hz. The...

SMD HLC-2 High Level Converter

CONNECT AMPLIFIERS TO YOUR FACTORY RADIO The typical purpose of the HLC-2 is to bridge the gap between factory audio systems and aftermarket audio amplifiers.  With it's ability to accept up to a 40V RMS BTL audio signal it is suitable for all...